You must have the correct flasher to purchase these
harnesses. The gen 1 and gen 2 flashing interface are NOT the
same.
The flasher box's that I sell for Gen 1 and Gen 2 Hayabusa / Bking
do not stay on the bike, only a small harness stays on the bike,
which you may purchase seperately if you are a shop and tune a lot
of bikes, or if you have a buddy with the same year as your bike and
you wish to share the flashing interface. Gen 1 consists of
the harness that goes from flasher box to 4 ecu pins, gauge data
wire on a t-tap, and battery ground on a ringlet. Gen
2 consists of just a 2 wire harness that goes from ecu connector to
yosh connector. The main harness that goes from flasher box to
yosh and sds connectors should stay with the flasher box, just the 2
wire harness is the only thing that stays on the bike and would need
additional items of to flash additional bikes.
|
